Peptide Dosage Calculator
// research reference tool — v2.0 Developed By TechHikers.com
Research Use Only. This calculator is for informational and research reference purposes only. Nothing on this page constitutes medical advice. Always consult a licensed healthcare professional before using any peptide compound.
Select Peptide
Dose Parameters
Typical range: 200–500 µg
Results
0.050 mL
Volume to inject
5.0
IU on syringe
2,500
µg/mL conc.
40
doses/vial
Syringe Visualization
Draw to the 5.0 IU mark — concentration: 2,500 µg/mL
Weekly Dose Schedule
Vial & Dosing Setup
Reconstitution Results
Final Concentration
2,500 µg/mL
Volume per dose 0.100 mL
IU on syringe 10.0 IU
Doses per vial 20 doses
Concentration vs Water Volume (5mg vial)
Step-by-Step Protocol
1
Warm up the vials. Remove the peptide vial and BAC water from the fridge. Let both sit at room temperature for 15–20 minutes. Cold liquids cause excessive foaming and can degrade the peptide.
2
Sterilize the stoppers. Wipe the rubber stopper of both vials with a fresh alcohol swab. Let them dry completely before inserting the needle.
3
Draw the BAC water. Use a clean 3 mL syringe. Draw the required BAC water volume based on your calculation above.
4
Inject slowly down the side wall. Tilt the vial so the water runs down the glass wall rather than hitting the lyophilized powder directly. This prevents denaturation.
5
Swirl — do not shake. Gently roll and swirl until fully dissolved. The solution should be clear and colorless. Shaking can break peptide bonds.
6
Store correctly. Refrigerate at 2–8°C. Most reconstituted peptides remain stable for 30–60 days. Label with the date. Keep away from light.
7
Draw your dose carefully. Clean the stopper before each injection. Draw slightly past your target, tap to remove air, then adjust to the exact IU mark shown in the calculator.
Typical Dosing Range by Peptide (µg)
Half-Life Comparison (hours)
Administration Frequency Guide
PeptideFrequencyTiming
Complete Reference Table
PeptideLowCommonHighHalf-LifeRouteCategory